Mastercam X 2 Handbuch How Do You Use Solid Sweep On MasterCam X 2?

How do you use solid sweep on MasterCam X 2? - mastercam x 2 handbuch

In the same way that the surface.

To do this,
Draw a circle 1 inch in plan view.
However, in the view from left
Draw a line from the center of the circle at a 60ish degree angle. There are 5 inches (this is not a 3D drawing all flat drawing)

Now go sweep in solids. Click on the circle and press OK. Then click on the track. It just blew the Circle Line, a solid.

Think of it as a vector in the direction of extrusion.